For example, paint on a wall that had inflation of what causes it and how do I fix this? In this article we will discuss the causes of paint and bubble solution.
Paint bubbling
caused by the end of the paint has better quality than the primer, base paint used has low standards, the use of plamur / putty on the surface of the fireplace with a poor quality, and any leakage or infiltration of water under a layer of water if there is trapped underneath, the water will be captured and inflated the layers of paint.In addition, painting the walls are still wet can also cause bubbles. Special common in repainting the walls are too thick so that the first layer of uneven drying or first layer of paint is completely dry yet.
So that inflation does not happen, do prevention as early as possible. The walls to be painted are completely dry cultivated. When done painting process, keep the first layer completely dry before subsequent paint coating.
However, if inflation has occurred, follow the steps below:
- Scrape the old paint down to the cement plaster.
- Fix it first if there is leakage at the surface.
- If there are cracks use a material that has good adhesion.
- Give at least 2 layers of Waterproofing Sealer is applied to cross.
- For the exterior could use as a prime Wall Sealer coat before the final paint.
- Application of good quality paint finish to get maximum results.
